Shooting
the Kel-Tec Sub 2000 with Laser Sight:
 Today
I test fired the Kel-Tec Sub 2000 with with our newest available
accessory the Sub
2000 Laser Sight I was very impressed with it's performance
so I figured I would blog about it.
The
Sub
2000 Laser Sight is very easy to use and bolts right
on to the picatinny
rail of the gun. It's made of light weight aluminum
so it adds very little weight to the overall weight of the
gun. The Laser is perfect for when you want to hit targets
dead on and because it's a visual sight you don't need to
look through the standard sights of the sub 2000 to hit
your target. Just position the red dot where you want the
bullet to go and squeeze. Perfect for those who want to
bump fire the rifle (scarface style. lol ). The
Laser is powered by 3 watch sized batteries and has a constant
on and off switch.
Shooting
with the Laser: My first shots were at 15 yards
and it was dead on, as you can see from the image below
I damn near drew a line across the targets mouth:
Next
I decided to push it back to 25 yards to see how it did
at body shots. Looking good. The red dot was still visible.
Again I was impressed. Fired it bump fire style and still
hit the body of the target in the upper chest and mid-section.
Check it out:
Then
I pushed the target back to the end of range at 50 yards
and for confirmation purposes I pasted on my Shoot N C target
to the mid section to see if I could hit it at 50 yards.
Shoot N C targets come in handy at these distances simple
because they give visual conformation of shot placement.
When the bullet hits the target the connect zone turns to
a bright yellow color. I shot the sub 2000 this time around
from a make shift bench rest and this time i missed 2 shots
out of a 15 round .40 glock mag but i was able to make the
other 13 shots connect:
The
laser made the sub 2000 so much more fun to shoot and it
does not affect it's ability to be concealed as it's not
too bulky. I ran like 300 rounds of .40 range ammo through
it that day and had the Laser on for over an hour and the
beam never faltered 
Thanks
for reading this. Share your thoughts below:
IMPORTANT: Requires the Picatinny
Rail to be attached to to the sub 2000
|
